Where does the power antenna wire go. How Do Power Antennas Work?

mazda

Where does the power antenna wire go

Not 100% sure, but I was fishing around under the dash over the weekend and I believe that is what I observed. I understand about the switch. I can still hear the antenna motor so I guess its not completely shot. This voltage is transferred through the remote turn on wire to the amplifier turn on circuit; when the amplifier senses this voltage, it turns the amplifier on. This should help you avoid having to run a bunch of wires back there. Installing a stereo into your Chevy Silverado is easy to do with our truck audio wiring diagram. I think the switch is not connected at the radio.

Nächster

I Need mobile.eyeslipsface.com a Power antenna wiring

Where does the power antenna wire go

The reel will catch the nylon cord and pull the antenna mast in. When power is no longer sensed through the Blue wire, it defaults to it's normal polarity and the antenna is lowered. I believe that the red one goes to switched power and the green one goes to your radio and recieves the power antenna signal. I've seen some cases where the power antenna unit actually had bad gears though. Now, the antennae does not work.

Nächster

Power Antenna won,t go up or down

Where does the power antenna wire go

In the meantime, install of your stereo and amplifier can be made easy with a plug and play kit. One wire, two possible connection points. Some of the more common options for connecting the remote turn on wire when using a factory head unit are to the wire connected to a power antenna older vehicles which do not turn off the antenna when not using the radio or to the vehicle's fuse box. Reason, if you turn the car off and the power wire is ignition switched it will stop retracting as soon as key is off. Just because your wiring harness has a connection for this wire, it doesn't necessarily mean that your car has this kind of motorized antenna. I have had the wires out a couple of times.

Nächster

Head Unit Has No Remote Wire

Where does the power antenna wire go

If it is external, all that is needed is to insert the nylon cord into the opening for the mast. You could try momentarily touching the constant power wire to the switch wire and see if the antennae engages then remove it and see if it goes back down. These changes are easy to see and notice, especially when you are installing an aftermarket stereo. More likely to be a broken mast cable, it comes with a new mast. Wiring the remote turn on wire with an aftermarket head unit is pretty straightforward. .

Nächster

Remote Turn On Wire: What it is and How to Install it

Where does the power antenna wire go

In some cases, the motor will not stop running even with the key off depending on where it gets its power. Have a helper turn the radio on. I believe when the power is taken away from the switch wire a capacitor at the motor brings it back down or something to that degree. Maybe using the motor would fix that. It hasnt worked, I'm replacing the stereo, found a lone white wire and attached the blue wire trigger from the radio to it.

Nächster

What is a power antenna wire on a car stereo

Where does the power antenna wire go

Normally you would leave it on so that it turns on when the head unit is on. It would just stay up; or stop halfway down, after the end user pressed the power button on the radio about the same time they turned the key off. With red on + and black on - if I shift the green wire back and forth from positive to negative it goes up and down. If the fuse is ok, then check to make sure that the antenna is properly plugged into the wiring. You have to take a picture of the relay or draw a sketch of the terminals to get an answer to that.

Nächster